Table of Contents
Advertisement
Main Menu
Pressure Plate, Clutch Disc
Installation
1.
Install the ring gear holder.
2.
Apply grease to the splines of the clutch disc, then
install the clutch disc using the special tools as
shown.
3.
Install the release bearing on the pressure plate.
4.
Install the pressure plate. Make sure the release
bearing does not come off.
Table of Contents
HANDLE
07936-3710100
CLUTCH ALIGNMENT SHAFT
07MAF-PR80100
RING GEAR HOLDER
07LAB-PV00100
07924-PD20003
5.
Torque the mounting bolts in a crisscross pattern
as shown. Tighten them in several steps to prevent
warping the diaphragm spring. Make sure the
release bearing does not come off.
or
6.
Remove the special tools.
7. Reinstall the transmission (see
section
13).
Advertisement
Chapters
Table of Contents
Troubleshooting
