Acura NSX 1997 Service Manual page 884

Main Menu
Troubleshooting
Tips and Precautions (cont'd)
Insert the connector all the way, and make sure it is
securely locked.
Position wires so that the open end of the cover
faces down.
Handling Wires and Harnesses
Secure wires and wire harnesses to the frame with
their respective wire ties at the designated locations.
Remove clips carefully; don't damage their locks.
Slip pliers under the clip base and through the hole at an
angle, then squeeze the expansion tabs to release the
clip.
After installing harness clips, make sure the harness
doesn't interfere with any moving parts.
Keep wire harnesses away from exhaust pipes and
other hot parts, from sharp edges of brackets and
holes, and from exposed screws and bolts.
Table of Contents
Face
open end
down
SNAP-RING PLIER
Seat grommets in their grooves properly.
Testing and Repairs
Do not use wires or harnesses with broken insulation.
Replace them or repair them by wrapping the break
with electrical tape.
After installing parts, make sure that no wires are
pinched under them.
When using electrical test equipment, follow the
manufacturer's instructions and those described in
this manual.
If possible, insert the probe of the tester from the wire
side (except waterproof connector).
Use a probe with a tapered tip.
Refer to the instructions in the Honda Terminal Kit for
identification and replacement of connector terminals.
NOT GOOD