Acura NSX 1997 Service Manual page 521

Main Menu
Driveshafts
Removal
6. Remove the wheel sensor from the knuckle and the
rear of the lower arm, then secure the wheel sensor
wire to the suspension arm.
NOTE:
• Do not disconnect the wheel sensor,
• Avoid twisting the wires when reinstalling the
wheel sensor.
V Corrosion resistant bolt
8 mm FLANGE BOLTS
22 N-m (2.2 kgf-m, 16 Ibf-ft)
WHEEL SENSOR 6 mm BOLT-WASHER
9.8 N m (1.0 kgf m, 7.2 Ibf-ft)
7. Disconnect the parking brake cable from the body.
8. Remove the flange bolt, then disconnect the toe
control arm from the body.
Corrosion resistant bolt
TOE CONTROL ARM
Table of Contents
PARKING BRAKE CABLE
8 mm BOLT-WASHER
22 N m (2.2 kgf-m, 16 Ibf-ft)
FLANGE BOLT
12 x 1.25 mm
93 N m (9.5 kgf in, 69 Ibf ft I
9. Hold the damper lower mount of stabilizer link with
a wrench, and remove the damper mounting nut.
Corrosion resistant nut
A DAMPER MOUNTING NUT
12 x 1.25 mm
Replace.
93 N-m (9.5 kgf-m, 69 Ibf-ft)
STABILIZER LINK
10. Hold the ball pin of the stabilizer link with a hex
wrench, and loosen the self-locking nut.
11. Remove the self-locking nut, then remove the stabi-
lizer link from the stabilizer bar and knuckle.
Corrosion resistant nut
REAR DAMPER
STABILIZER LINK
WRENCH
HEX WRENCH
SELF-LOCKING NUT
12 x 1.25 mm
Replace.
83 N m (8.5 kgf m, 61 Ibf-ft)
SELF-LOCKING NUT
12 x 1.25 mm
Replace.