Acura NSX 1997 Service Manual page 49

Main Menu
NOTE: Perform steps 53 thru 56 only if the engine
assembly is to be removed from the subframe.
53. Remove the adjusting bolt and flange bolt, then
separate the lower control arm from the subframe
(see section 18).
54. Remove the flange bolt, then separate the toe control
arm from the subframe (see
CAUTION: Make sure that the reference marks on
the control arm are aligned.
55. Remove the heat shield form the intermediate shaft
bearing support, then remove the driveshafts (see
section 16).
NOTE:
• Coat all precision finished surfaces with clean
engine oil.
• Tie plastic bags over the driveshaft ends.
56. Attach a chain hoist to the engine.
Remove the front and rear mount mounting bolts,
then separate the engine from the suspension and
the beam assembly.
CAUTION: Do not hit the engine oil cooler on the
rear right beam bracket.
Table of Contents
section 18).