Table of Contents
Advertisement
Main Menu
Transmission Assembly
Installation
MOTE: Use only Super High Temp Urea Grease (P/N 08798 - 9002).
1. Place the transmission on the transmission jack, and raise it to the engine level.
Check that the two dowel pins are installed in the clutch housing.
2. Set the release fork to the clutch housing.
3. Install the two transmission housing mounting bolts and engine stiffener.
4. Install the three rear transmission mounting bolts.
5. Loosen the front engine mounting bolt, then install the two front engine
mounting bolts to the transmission side.
6. Remove the transmission jack.
7. Install the clutch housing cover.
8. Install the release fork in the release hanger, then install the slave cylinder.
9. Connect the shift cable and select cable. Take care not to bend the cables.
10. Install the upper cover, change wire bracket and lower cover.
11. Install the upper control arm mounting bolt.
Table of Contents
Advertisement
Chapters
Table of Contents
Troubleshooting
