Acura NSX 1997 Service Manual page 454

Main Menu
Secondary Shaft
Inspection/Installation
NOTE:
• Lubricate all parts with ATF during assembly.
• Before installing the O-rings, wrap the shaft splines
with tape to prevent damage to the O-rings.
1. Assemble the parts below on the secondary shaft.
NOTE:
• Install the thrust washer so that the large cham-
fer on the circumference faces the 2nd clutch
assembly.
• Do not install the O-rings during inspection.
Table of Contents
2. Hold the 2nd clutch assembly against the 3rd gear.
Measure the clearance between the 2nd gear and
thrust needle bearing using a feeler gauge.
NOTE: Take measurements in at least three places,
and take the average as the actual clearance.
STANDARD: 0.01 - 0.07 mm
(0.0004 - 0.0028 in)