Omron LD-60 User Manual page 118

Chapter 8: Maintenance
Figure 8-13. Spring-Compression Hole
7. The drive assembly is held in place with three nuts on studs across the top, and two
sets of two screws at each side, near the bottom of the assembly.
Remove the three nuts and four screws (and their washers) holding the drive assembly
to the platform.
Retain these nuts, screws, and washers for attaching the new drive assembly.
Figure 8-14. Mounting Studs and Nuts at top of Drive Assembly
LD Platform User's Guide, 11970-000 Rev E
Page 118 of 142