Delta Electronics AH500 Operation Manual page 28

Hide thumbs Also See for AH500:

Table of Contents

13. Hot swap

The AH500 series I/O modules support the on-line uninterruptible hot swap. When the system runs,

users can replace the module which breaks down without disconnecting the module. After the module

is replaced, the new module runs normally. Users do not need to set the module manually or switch

14. Supporting the on-line debugging mode

After a single instruction step has been complete, or after a breakpoint is specified, users can easily

find the bug in the program by means of the on-line debugging mode supported by the AH500 series

If users want to enter the debugging mode, the CPU module must run. After users enable the on-line

monitoring function, they have to click

language to programming language, but the same operation applies to these programming languages.

For the AH500 series PLC, structured texts do not support the debugging mode, and sequential

function charts support the debugging mode during the action and the transition.

Step 1: Setting the PLC to RUN

. The debugging screen varies from programming

C h a p t e r 1 I n t r o d u c t i o n

Chapters

Table of Contents