Hitachi SJ Series User Manual page 99

Chapter 9
・Sections of display screen on the operator keypad
STOP (A) NRDY (B)
Output Frequency
(C)
FA-01
Main speed command (Operator keypad)
(D)
(E)
Menu 0.00Hz
oFW
<a> Power status display
No. Indication Description
a1 (None) There is input to the main power
supply/control power supply.
a2 CTRL There is input to the control power supply.
a3 24V The device runs with 24V input to P+/P-.
(Tips)
・Indicates the status of power input. When CTRL or 24V
is displayed, main power is not input, which makes
operation impossible. Check the power supply.
<b> Display of SET function operation status
No. Indication Description
b1 M1 The [SET] terminal is not selected or the
[SET] terminal is selected but the function
is disabled. (common setting and first
setting are enabled)
b2 M2 The [SET] terminal is selected and the
function is enabled. (common setting and
second setting are enabled)
・If the [SET] terminal is not used, M1 is displayed. If the
center of parameter is "-" (common setting such as [AC-
01]) or "1" (first setting such as [AA111]), the setting is
enabled, and "2" (second setting such as [AA211]) is
ignored.
<a> <b> <c> H03 <d>
CTR M1 UTL
<h> <g>
<f> <e>
SIM Ez_S TRQ STO
0.00 Hz
0.00 Hz
[0.00-60.00]
Optional
(G)
(F)
device
<c> Selection of parameter display
No. Indication
c1 (None)
c2 UTL
c3 USR
c4 CMP
c5 MON
(Tips)
・This section is displayed when the display limit function
is working. If there is a hidden parameter, change the
setting in [UA-10].
<d> Display of monitor screen No.
(Tips)
・ Displays the screen number of each monitor. When
making inquiries, please tell us the number of monitor
displayed on your screen. The list of monitor screen
numbers is shown in the next page.
<e> STO function display
(Tips)
・If the function is displayed, it means the current is shut
off.
* For details of the STO function display, please contact us.
<f> Display of control command mode
No. Indication
f1 (None)
f2 TRQ
f3 POS
(Tips)
・Indicates the mode of control operation.
<g> Display of EzSQ operation mode
No. Indication
g1 (None)
g2 Ez_S
g3 Ez_R
(Tips)
・You can check whether the EzSQ function is working.
<h> Display of special function status
No. Indication
h1 (None)
h2 AUT
h3 SIM
(Tips)
・If the function is displayed, it means that the device is in
the special state.
9-4
Operating Instructions
Description
All-parameter display mode.
Individual-function display mode.
User-setting display mode.
Data-comparison display mode.
Monitor display mode.
Description
The speed control mode.
The torque control mode.
The position control mode.
Description
EzSQ is not selected.
The EzSQ program is stopped.
The EzSQ program is working.
Description
The device is not in the special status.
The device is auto-tuning.
The device is in the simulation mode.