Hitachi SJ Series User Manual page 82

Chapter 7
Recommended terminals for wiring
・For the convenience of wiring and improvement of
connection reliability, it is recommended to use rod
terminals with the following specifications.
・Rod terminals with sleeve
Wire size
2
mm (AWG)
0.25 (24)
0.34 (22)
0.5 (20)
0.75 (18)
*1) Manufacturer: Phoenix Contact
▼
Method of wiring/detaching wires
1. Press in the orange portion on the control circuit
terminal block using a slotted screwdriver (2.5mm
or less in width).
(The wire insertion slot opens.)
2. While pressing the slotted screwdriver in the
terminal block, insert the wire or rod terminal into
the wire insertion slot (round hole).
3. Extract the slotted driver to fix the wire.
2.5mm
Rod terminal
L1 [mm]
model *1
AI 0,25-8YE 8
AI 0,34-8TQ 8
AI 0,5-8WH 8
AI 0,75-8GY 8
Press in the orange
portion using a
slotted screwdriver
Wire Connection and Optional Devices
・For the control circuit terminal block, a spring clamp
type terminal block is employed.
L2 [mm] φd [mm]
12.5 0.8
12.5 0.8
14 1.1
14 1.3
Caulking tool CRIMPFOX UD 6-4 or CRIMPFOX ZA 3
!
・Also when extracting the wire, extract it while the
orange portion is pressed in with the slotted
screwdriver (the wire insertion slot is open).
Insert the wire
7-27
φD [mm]
2.0
2.0
2.5
2.8
Extract the slotted
driver to fix the wire