Hitachi SJ Series User Manual page 49

Chapter 6 Chapter 6
◆ Notes for P1
Notes for P1-01240 01240-L (P1-220L)
For the use of P1 For the use of
low duty (VLD), follow the installation low duty (VLD), follow the installation low duty (VLD), follow the installation low duty (VLD), follow the installation
procedures shown in the drawings below. procedures shown in the drawings below. procedures shown in the drawings below. procedures shown in the drawings below.
Procedures: Procedures:
(1) (1) Tighten (four) spacers to the (upper and lower) brackets Tighten (four) spacers to the (upper and lower) brackets Tighten (four) spacers to the (upper and lower) brackets Tighten (four) spacers to the (upper and lower) brackets Tighten (four) spacers to the (upper and lower) brackets
as shown in Figure 1 using (four) M3×8 screws included as shown in Figure 1 using (four) M3×8 screws included as shown in Figure 1 using (four) M3×8 screws included as shown in Figure 1 using (four) M3×8 screws included as shown in Figure 1 using (four) M3×8 screws included
in the package. in the package. (Tightening torque 0.6 to 0.8 Nm) (Tightening torque 0.6 to 0.8 Nm) (Tightening torque 0.6 to 0.8 Nm)
Step Step (1)
Step (2)
Screws prepared Screws prepared
on your own on your own
Step (2)
Screws prepared Screws prepared
on your own on your own
Figure How to install Figure How to install Figure How to install
220L)
P1-01240-L(P1 L(P1-220L) at very 220L) at very
M3×8 screw M3×8 screw
M3×8 screw M3×8 screw
Change [Ub Change [Ub-03] to 00 to set VLD. 03] to 00 to set VLD. 03] to 00 to set VLD.
(2) Install P1-01240 (2) 01240-L(P1-220L) on the wall using four
screws prepared on your own. screws prepared on your own. screws prepared on your own.
Step (1)
Spacer
Step (1)
Spacer
Figure Front and right side diagrams Figure Front and right side diagrams Figure Front and right side diagrams Figure Front and right side diagrams
6-10
Installation Installation Installation
220L) on the wall using four 220L) on the wall using four
Wall Wall