Firstech CM-7000 Master Manual page 9

CM7 Master Guide
1. RPS Touch (Remote Paging Sensor)
The new RPS touch has multiple features including: remote paging, 4-digit pin unlock/disarm, and arm/
lock. All features are operated with a simple touch of the sensor. Note: check feature 3-16 to make sure it
is set to RPS touch setting. (default to RPS touch)
RPS Touch and car call functions do not require programming, however to unlock/disarm your vehicle you
must program a 4-digit passcode (numbers 1 through 10 only) you can view our video library for
programming instructions at: www.firstechdata.com NOTE: If you enter the wrong code more than 5
times within 30 minutes the RPS touch function will be disabled for 1 HOUR
Programming Your Code
STEP 1: Choose your RPS Touch 4-digit code. '0' is not available.
STEP 2: Turn ignition to the 'ON' position and leave driver's door open. (Door Input must be connected)
STEP 3: Hold your finger over the 'Red Circle' icon for 3 seconds.
STEP 4: When the siren chirps and LEDs flash in a circular pattern, tap on your first number. (Hold the
number for 2.5 seconds to choose 6 through 10.) After choosing your first number you will get 1
siren chirp and LEDs will flash in a circular pattern.
STEP 5: Repeat Step 4 until all four digits are set. You will get 1 siren chirp and 1 parking light flash.
Repeat Steps 2 - 5 if you get 3 chirps and light flashes. Your RPS Touch is now programmed.
Alarm rearm and lock
To rearm hold your finger on the 'Red Circle' for 3 seconds.
Alarm disarm and unlock
To disarm hold your finger over the 'Red Circle' for 3 seconds. Once the LEDs start their circular pattern,
enter your 4-digit code by touching the window with the flat part of the tip of any finger over the number for
each digit of your code. (Refer to Step 4 above or training video at www.firstechdata.com) Two seconds
after entering the 4th digit, your system will first re-arm/lock. In two seconds, it will disarm/ unlock.
2 Way LCD remote paging
To page a 2 Way LCD remote, hold your finger over the 'Red Circle' twice.
Touch Panel Sensitivity
To change touch sensitivity, open the driver's door, hold the button on the back of the RPS Touch until the
LEDs go out. Release button and tap again. The number of solid LEDs represent sensitivity of touch, 1
being the lowest, 5 the highest.
RPS Touch on or Off
You can turn the RPS Touch off from your remote. Just follow the instructions below:
Copyright 2016 Fi rstech ,
LLC.
Alarm and Starter System
www.firstechdata.com
Page 9