Firstech CM-7000 Master Manual page 14

CM7 Master Guide
FT-EZGO Setup
The FT-EZGO from Firstech will unlock/disarm the vehicle when in range. It is capable of proximity lock/arm
and unlock/disarm when in or out of range off the vehicle. There is a manual override button located on
the back of the EZ-GO remote. It will lock/arm, unlock/disarm by press and releasing the button for ½ of a
second (0.5 seconds). It will also trigger the trunk release output by press and releasing the button for ½ second
(0.5 seconds) then holding for 2.5 seconds.
Installing The FT-EZGO
STEP 1: Set Option 1-14 to Setting 2, 3 or 4
STEP 2: Connect included Blue 6 Pin (With Ground Wire) to Black 6 Pin to control module. If
connecting to a 4 Pin to 4 Pin antenna, use the included 6 Pin to 4 Pin adapter.
STEP 3: Connect the ground wire from the included 6 Pin to 6 Pin cable to vehicle's ground.
Failure to connect this wire WILL result in damage to your FT-EZGO antenna (ANT- RFID).
STEP 4: If you are using an additional RF kit the antenna cable will connect to the blue 6 pin connector
on the EZ-GO antenna either directly or using the 6 to 4 pin adapter harness included with the EZ-
GO kit.
STEP 5: Find a spot to mount your ANT-RFID on the windshield. This is recommended for optimum
range. For more specific mounting location information visit us at www.firstechdata.com under
the Authorized Tech section document titled: "FT-EZGO Recommended Mounting Locations."
STEP 6: Program your EZ100-R using the standard remote programming procedure along with any
additional RF Kit remotes to the control module (Maximum 4 Remotes including EZ100-R). You
are now ready to test your FT-EZGO system.
Testing The FT-EZGO
STEP 1: Turn the proximity lock/unlock feature on by holding the button on the EZ100-R for 8-10
seconds. You will get one parking light flash and/or siren chirp. To deactivate the proximity
feature simply hold the button again for 8-10 seconds and you will get two parking light flashes
and/or chirps to indicate your feature is off.
STEP 2: Proximity locking/unlocking-The main control module will monitor all of the zone inputs that
are connected analog or data. In order for the proximity Lock/arm function to work all zones
must be closed and ignition off. Once the EZGO remote leaves the proximity of the antenna it
will lock/arm within 15 seconds.
a. the proximity unlock feature will unlock the doors as soon as its within proximity of the
EZGO antenna once the system has proximity locked.
Copyright 2016 Fi rstech ,
LLC.
Alarm and Starter System
www.firstechdata.com
Warning:
Page 14