Remote Programming Routine - Firstech CM-7000 Master Manual

CM7 Master Guide

Remote Programming Routine

IMPORTANT: All remotes must be coded to the control module prior to performing all operations.
STEP 1: Activate programming mode by manually turning the vehicle's key between the Ign On and Off
(or the Acc & On positions) five times within 10 seconds. The vehicle's parking lights will flash
once with the successful completion of this step.
STEP 2: Within a 2 second period after the 5th ignition cycle tap (a quick 0.5 second press and release)
the Lock button on the Firstech remote. The parking lights will flash once to confirm the
transmitter has been coded. Repeat step 2 for each additional remote, up to 4.
NOTE: If using one of the FMX frequency remotes you will need to tap the programming button
on the antenna after the key cycles. The LED on the antenna will come on solid red Tap
(a quick 0.5 second press and release) the lock button on the remote. The LED flash green
for each remote that is successfully programmed)
**NEW**
Remote programming procedure: PTS (Push to Start vehicles) application
STEP 1: Set the vehicle to the ignition or "ON" position
STEP 2: Within 5 seconds push to the "OFF" position
STEP 3: Within 5 seconds set the vehicle to the ignition or "ON" position (do not start)
STEP 4: Within 5 seconds depress and release the foot brake 3 times *parking lights will flash 1 time to
indicate remote programming is enabled
STEP 5: Tap (a quick 0.5 second press and release) the lock button on the remote * the parking lights
will flash 1 time indicating the remote code has been accepted (Repeat step 5 for each
additional remote, up to 4
STEP 6: After 10 seconds of no valid remote codes being transmitted the CM will automatically
exit programming mode
NOTE: If using one of the FMX frequency remotes you will need to tap the programming
button on the antenna after the foot brake presses. The LED on the antenna will come on
solid red Tap (a quick 0.5 second press and release) the lock button on the remote. The LED
will flash green for each remote that is successfully programmed)
Note: If no valid remotes are programmed the CM will enter valet mode.
Copyright 2016 Fi rstech ,
LLC.
Note: if you only have 2 remotes please program each remote twice.
**parking lights will flash twice signaling the end of programming mode.
Alarm and Starter System
www.firstechdata.com
Page 6