Table of Contents
Advertisement
CM7 Master Guide
STEP 2: Scroll through menu waiting for 1 parking light flash and/or siren chirp per line.
STEP 3: Once finished scrolling through menu, wait for the parking lights and/or siren chirp to confirm the
option number. i.e. option 2-04 will flash and/or chirp 4 times. Select your option using the Lock, Unlock,
Trunk, or Start buttons.
Resetting to Factory Defaults: To reset the options in a menu, enter the menu using your remote. To reset
options with a 2 Way remote, tap the Trunk button 3 three times. To reset options with a 1 Way remote, tap
the Key/Start button 3 times. Wait for parking lights to flash and/or siren chirp between each tap. After the
third tap, the menu will reset back to default. This must be done for each option menu that must be reset.
Troubleshooting
Remote Start Error Codes
If the remote start fails to start the vehicle, the parking lights will flash three times immediately. Following
those two flashes the parking lights will flash again corresponding to the error table below:
2 Way remotes will display the error number "Start Err##" on the LCD.
Remote Start Shutdown Error Codes
If the remote start sequence has been completed and the vehicle shuts down, the vehicle's parking lights
will flash 4 times, pause then flash again with the error code. Tap button 4 on 2 Way remotes to initiate the
shutdown error codes. On 1 Way remotes hold the Trunk and Start buttons together for 2.5 seconds.
Copyright 2016 Fi rstech ,
LLC.
Number of
Parking Light
Flashes
Motor running or must program tach before 1st remote
1
start
2
Key in ignition on position
3
Door open (manual transmission only)
5
Foot brake on
6
Hood open
7
Reservation off (manual transmission only)
8
Tach or tachless sensing failure
9
DAS sensor shutdown
10
System is in Valet Mode
Alarm and Starter System
Remote Start Error
www.firstechdata.com
Page 62
Hide quick links:
Advertisement
Table of Contents
