Firstech CM-7000 Master Manual page 42

CM7 Master Guide
FO2 - On: this option will enable the advanced algorithm to allow the CM7 to release the starter and
consider the vehicle running. This option is better suited for late model computer-controlled vehicles or
older vehicles with poor starting conditions. Note: feature 2-10 must be set to option 3 for it to work
properly. If there is tach signal input to the CM7 either analog or data interface module, this option will
not operate consistently. NOTE: Option 2 will enable the system check for feature 2-10 option 4.
please see 2-10 FO4 for details*
2-12 Crank Time: This feature allows the user to add or remove crank time to the selected option for feature
2-10 (engine sense).
FO1 - Standard: (default crank time no change).
FO2 - +200mS: To standard crank time of option selected on feature 2-10.
FO3 - +600mS: Adds 600 milliseconds to standard crank time of option selected on feature 2-10.
FO4 - (-)200mS: releases the starter output 200 Milliseconds earlier than standard crank time of option
selected on feature 2-10.
2-13 Timer Mode: (Note: Must be set to on to operate timer mode). This feature enables the user to activate and
deactivate Timer Mode (see option 2-06) using the Firstech remote or accessory (see the user manual for
that remote for instructions).
FO1 - Off: (default)
FO2 - On: user must still activate timer mode using their Firstech remote or accessory.
FO3 – START with Alert: This option when enabled will allow for the remote start to active and will also
send an extreme temp alert (based on features 2-05, 2-06, 2-08, 2-09 option setting) to a programmed
Firstech 2-way LCD remote or Drone in the form of "CAR CALL" (user must still activate timer mode using
their Firstech remote or accessory)
FO4 – Alert ONLY: This option when enabled will ONLY send an extreme temp alert (based on features 2-
05, 2-06, 2-08, 2-09 option setting) to a programmed Firstech 2-way LCD remote or Drone in the form of
"CAR CALL" (user must still activate timer mode using their Firstech remote or accessory)
2-14 NEW **Reservation Mode "Enter with": ATTENTION: YOU MUST select a reservation "enter
with" option in order to enable manual transmission capabilities.
This feature will allow the user to customize the process used to enter reservation mode (manual
transmission set up mode) Once user has entered reservation mode there is a 5-minute window to "set"
or complete reservation mode before the CM cancels reservation mode.
FO1 – OFF (Automatic transmission) (default): This will disable reservation mode and should be
used for Automatic transmission vehicles.
FO2 – Parking/E-Brake set: When set to this option, when the CM sees the parking/E-Brake input
(analog or through data) it will activate the necessary ignition, accessory outputs and interface
module, to leave the vehicle running and enter manual transmission reservation mode.
FO3 – Parking/E-Brake set + Hold Start button for 2.5 seconds: When set to this option, the CM
will need Parking/E-Brake input (analog or through data) AND a start command from a remote (hold
start button for 2.5 seconds) to activate the necessary ignition, accessory outputs and interface
module, to leave the vehicle running and enter manual transmission reservation mode.
Copyright 2016 Fi rstech ,
LLC.
Alarm and Starter System
www.firstechdata.com
Page 42