Firstech CM-7000 Master Manual page 13

CM7 Master Guide
STEP 4: Once the sensor has been selected hold the programming button for 2 seconds to
confirm selection and enter sensitivity adjustment. The adjustment options will
now be accessible with default setting displayed. (sensitivity options will be
shown in table below.)
STEP 5: push the programming button repeatedly until desired sensitivity level is reached
(setting 0 will indicate sensor is OFF => except option 2 window break
sensor conditions)
STEP 6: Hold programming button for 2 seconds to save sensitivity setting. After the
setting is saved the sensor will start over at sensor 1 again. (if the programming
button is not pressed within 5 seconds after setting the LED will flash 2 times
save the setting and exit that sensor programming)
STEP 7: Turn ignition off to exit programming
Copyright 2016 Fi rstech ,
LLC.
Alarm and Starter System
www.firstechdata.com
Page 13