Firstech CM-7000 Master Manual page 23

CM7 Master Guide
Connector 4 (CN4), Black 20-Pin: Blade Connector
This connector is used only if you are installing a Blade-AL or Blade-TB. The wiring harness for this
connector only comes with the Blade cartridge. Please refer to the Blade install guide for wire description
http://compustar.idatalink.com.
Connector 5 (CN5), Grey 20-Pin: Programmable Output Channel (POC)
IMPORTANT: Odd Pin numbers 1-15 are programmable for up to 30 different output types. Refer to
Special Option Group 2 for complete details. Even numbers pins 2-20 do offer 5 PIC (programmable input
channels) features that are selectable using the OP500 updater. Note: These inputs/outputs are subject to
change, for the latest software update and feature table please visit compustar.idatalink.com or
www.firstechdata.com
Pin 1 Blue/white - [POC 1] Starter Kill: 250mA latched negative (-) output when armed and during remote
start (while running) that can be used with an FT E-LOCK to interrupt a starter wire protecting from theft
or grinding the starter during take over. Caution: If this wire is being used to trigger multiple aftermarket
accessories it must be diode isolated for each one. Note: There are 30 additional POC setting options
for this POC.
Pin 2 Brown - Siren: 600mA (+) output can be connected to the positive lead of an aftermarket siren. This will
produce output with arm/disarm, full alarm, and panic as a default setting. This can be changed based on
feature 3-09 option settings. The length of output for the arm/disarm chirps can be changed using feature 3-02
settings
Pin 3 White - [POC 2] Horn:250mA negative (-) output. This is an optional output that will provide a fixed
30mS negative output when triggered by the remote(s). The output control is based on feature 3-08
option setting. Note: There are 30 additional POC setting options for this POC.
Pin 4 Light Blue/White - Brake 12V positive (+) input: This wire must be connected as it provides a
shut down for the remote start. It is also required to enter and exit Valet Mode. The proper wire will test
(+) 12V while the foot brake is pressed.
Pin 5 Blue/Lt. Green - [POC 3] Lock 250mA, 800mS (-) negative output: This is an optional output that
will provide only negative (-) output pulse for locking doors. System will lock doors and arm alarm.
IMPORTANT: You must reverse polarity for (+) trigger door lock systems using the FT-DM700,
FT- DM600 or relays. For additional lock settings review Option Group 1. Note: There are 30
additional POC settings for this POC.
Pin 6 Light Blue - [PIC 1] Parking / Emergency brake (default setting) negative (-) programmable input:
This input is required for manual transmission/reservation and Turbo Timer mode. The proper e-brake
wire will provide a (-) trigger when parking / emergency brake is set, and the key is in the ignition or
"on" position. This wire or input is required for manual transmission and turbo timer mode. There are
additional options for this PIC. Please see Special Options Group 3.
Copyright 2016 Fi rstech ,
LLC.
Alarm and Starter System
www.firstechdata.com
Page 23