Firstech CM-7000 Master Manual page 10

CM7 Master Guide
STEP 1: Enter remote programming mode by holding down buttons 2+3 (Trunk and Key/Start buttons
on 2W901R-SS) simultaneously for 2.5 seconds. The remote will beep once and the LCD or
read "REMOTE MENU" indicating that you have entered programming mode.
STEP 2: Scroll through the remote options by taping button 3 or 4 (Function button 2W901R-SS).
Once the LCD RPS icon flashes reads "RPS-ON" tap button 1 or (Lock button 2W901R-SS)
to turn this feature on. The LCD will read "RPS-OFF"
STEP 3: Exit remote programming by holding down buttons 2+3 (Trunk and Key/Start 2W901R-SS)
buttons simultaneously for 2.5 seconds. The remote will beep indicating that you have
successfully exited programming.
RPS (Remote Paging Sensor) Unlock/Disarm
RPS and car call functions do not require programming, however to unlock/disarm your vehicle you must
program a 4-digit passcode (numbers 1 through 10 only) using the instructions below:
STEP 1: Disarm/unlock the alarm (remote must be programmed first) and choose a 4-digit code. You
cannot have zeros.
STEP 2: Turn ignition key to the "on" position and leave the driver's door open.
STEP 3: Knock on the windshield in front of the RPS a total of 5 times (each time you knock the LED on
the RPS will flash RED). The LED will begin to flash rapidly in BLUE with successful
completion of this step.
STEP 4: Enter the first digit of the desired four-digit pass code by knocking on the windshield in front
of the RPS the desired number of times. For example, to enter 3, knock on the sensor 3 times
(each time you knock the LED will flash RED) then wait.
STEP 5: The LED on the RPS will confirm your first number by flashing BLUE slowly. Once the LED
begins to flash rapidly in BLUE, enter your second number by repeating step 4.
STEP 6: Repeat steps 4 & 5 to enter all four numbers.
STEP 7: Turn the ignition OFF - the RPS disarm/unlock passcode is now programmed. Follow steps 3 –
5 to enter you disarm/unlock code.
Alarm rearm and lock
To rearm, knock on your sensor 5 times.
Alarm disarm and unlock
To disarm, knock on your sensor 5 times. Wait for the Blue LEDs to flash rapidly. Follow STEP 4 and 5
above to enter your 4-digit passcode.
2 Way LCD remote paging
To page a 2 Way LCD remote just knock on the RPS twice.
Copyright 2016 Fi rstech ,
LLC.
Alarm and Starter System
www.firstechdata.com
Page 10