Frequently Asked Questions - Firstech CM-7000 Master Manual

CM7 Master Guide
Alarm LED Diagnostics
When the alarm is triggered the LED on the RPS (if installed), Secure Valet (if installed) and the LED (if
installed) will flash a certain amount of times as shown in the table below. This is intended for users with 1
Way remotes.

Frequently Asked Questions

I have everything hooked up and the system will not respond.
A: The remotes need to be programmed. Review the "Common Procedure" section of this manual.
When remote starting, the siren chirps 3 times and parking lights flash 3 then 1 time.
A: You must program tach before remote starting. Also, be sure to check the foot brake and ignition wires on
the CM7000 and CM7200.
I am trying to program the control module with the OP500 Option Programmer and it flashes
"ER 01" when I plug it in to the antenna cable. What should I do?
A: Make sure that the system is not locked/armed. The last thing to check is the antenna cable or antenna
extension cable – make sure this is not damaged. If you need to, try another cable. When the OP500 is
working properly, it will read "success good."
What is the green/white wire loop inside the brain module?
A: This wire determines the transmission mode. With the loop intact, the system is set for manual
transmissions. With the loop cut, the system is set for automatic transmission.
Copyright 2016 Fi rstech ,
LLC.
Number of
Parking Light
Flashes
1 Lost engine sensing signal (Tach/Alternator/Tachless)
2 Lost emergency brake signal (Manual Transmission)
3 Foot brake triggered
4 Hood pin triggered
2 Flash
3 Flash
4 Flash
5 Flash
6 Flash
7 Flash
8 Flash
9 Flash
10 Flash
Remote Start Shutdown Error
Door Input
Shock stage 1
Shock stage 2
Tilt
Ignition on
Hood Input
Trunk Input
AUX sensor stage 1
AUX sensor stage 2
Alarm and Starter System
www.firstechdata.com
Page 63