Technical Support Contacts - Firstech CM-7000 Master Manual

Hide thumbs Also See for CM-7000:

Master manual (56 pages)

Table Of Contents

Table of Contents

CM7 Master Guide

How do I take the system out of Valet Mode with a 1 Button Remote?

A: Turn the ignition on and tap the foot brake 10 times within 10 seconds.

Why are the ignition-controlled door locks option not working?

A. Check option 1-09. It should be set on 2 or 3. The option must also be turn on via the remote. On 2

Way LCD remotes tap the Lock and Start Buttons for a half second, the parking lights will flash once to show

the option is turned on. On 1 Way remotes tap the Lock and Start buttons for a half second.

The vehicle remote starts when disarmed, but not when armed.

A: The starter kill relay was installed backwards. Check to make sure the yellow/black wire is going to the

key side of the starter wire and that the yellow wire is going to the engine side.

The vehicle starts and shuts down 3 times in a row.

A: This usually means that the engine sensing mode is not working correctly. If you are using a coil, change to

an injector or try alternator sense mode.

On the brain, how do I set the auxiliaries?

A: You must have an Option Programmer (FT-OP500-KIT) to set the auxiliaries on the CM4000, CM4200-

DX, CM4300, CM5000, CM5200, CM6000, CM6200, CM6300, CM7000 and CM7200. First choose two

POC wires on CN5 that you are not using. With the OP500 go into the Special Option Group 2 and set those

POC's to Aux 1 and Aux 2. Review the "Special Option Group" programming section of this manual. On the

CM7 Series control modules, Auxiliary 1 is preprogrammed on CN5, Pin 3, White Wire.

"Knibb High School Football RULES!!"