Table of Contents
Advertisement
CM7 Master Guide
Jumper 4 (Accessory, 2nd Ignition, 2nd Starter)
This Jumper offers additional high current output options using the default Accessory wire on connector one
(CN1 white wire). When selected, this wire provides additional positive (+) Ignition or Starter output instead of
Accessory.
Setting Auxiliary Outputs on Connector 2
You Must Have the OP500 Option Programmer
Setting auxiliary outputs on the control module involves the Programmable Output Connector wires (POCs).
Choose two odd pin wires that you are not using on the grey 20 pin connector. For example, we will use POC 7
and 8.
STEP 1: Plug in OP500 and use the Right or Left Arrow Button to scroll through the menu to POC 7 and
POC 8 on LCD Line 1.
STEP 2: Use the Up or Down Arrow Button to change the lower number on LCD Line 2 to 10 – Auxiliary
1 or 11- Auxiliary 2.
STEP 3: Scroll up the menu to Option 4-01 and 4-02 and set the options. Please see the Option Table for
details.
STEP 4: Our control modules have a secure auxiliary option 4-05. This requires you to tap the Start
Button before you tap the Trunk Button for Aux 1 or Hold Trunk + Start for 2.5 an then tap
Trunk for Aux 2. On 1-Way remotes you must hold the Trunk and Start Buttons for 2.5
seconds then tap the Trunk Button for Aux 1 or the Start Button for Aux 2.
STEP 5: If you need to change the time settings of the outputs, scroll down to AU1 or AU2 on the
OP500. LCD Line 2 is the timed output. Note: with an OP500 update v.31 (www.
firstechdata.com) you will now be able to allow for timed AUX outputs of up to 15
minutes.
STEP 6: Hold the "W" Write button for 3 seconds to save all the options.
Copyright 2016 Fi rstech ,
LLC.
Alarm and Starter System
www.firstechdata.com
Page 16
Hide quick links:
Advertisement
Table of Contents
