Firstech CM-7000 Master Manual page 58

CM7 Master Guide
STEP 2: Use the left or right arrow keys on the OP500 to select option. Use the up or down arrow
buttons to select the option setting. "1" is the default setting, "2", "3", and "4" are the
optional settings.
Special Option Group 1: Change the timed output of the Diesel Timer or Auxiliaries 1
through 7.
Special Option Group 2: Change the Programmable Output Connections on the grey 20 pin
harness.
STEP 3: Hold the "W" (Write) button for 3 seconds. This finalize option changes to the control
module. Wait until OP500 displays "Success" before disconnecting.
To reset the options, hold the "R" (Reset) button and "W" (Write) buttons for 3 seconds. Then
hold the "W" button for 3 seconds.
Option Programming with FT-OP100 (valet button) (Limited feature group access 1-4)
STEP 1: Make sure the Control Module is in a disarmed/unlocked state
STEP 2: Connect FT Valet OP-100 button to the CM's 4 pin blue antenna port
STEP 3: Go to Ignition on (without starting) + Foot brake input applied (in case of CM2305/CM7300
use door input in place of foot brake input)
STEP 4: Push the valet button 5 times holding it on the 5
the desired feature group:
1) 2 seconds → Option Group #1 (w/ light flash 1 time and siren/horn 1 chirp)
2) 4 seconds → Option Group #2 (w/ light flash 2 times and siren/horn 2 chirps)
3) 6 seconds → Option Group #3 (w/ light flash 3 times and siren/horn 3 chirps)
4) 8 seconds → Option Group #4 (w/ light flash 4 times and siren/horn 4 chirps)
If you would like to reset all features to their default option setting push the valet button 10 times and
th
hold on the 10
to confirm reset.
STEP 5: Once the Option group has been selected release the programming button. Then push and
release the programming button again to select the feature number you wish to change. Once
selected, wait for the parking light flash, and siren/horn to sound confirming the feature
number you've selected.
STEP 6: Once you have confirmed the feature you've selected push and release the valet button to
select the desired option. Once selected wait for the parking lights to flash and the siren/horn
to sound confirming the option you have selected.
Copyright 2016 Fi rstech ,
LLC.
time. Once complete, the parking lights will flash, and siren/horn will sound 5 times
Alarm and Starter System
th
time for the following time lengths to reach
www.firstechdata.com
Page 58