Table of Contents
Advertisement
CM7 Master Guide
Valet Mode
Valet Mode disables all system features except for the keyless entry. Use Valet when servicing or loaning your
vehicle to others to avoid any inconvenience or mishap when operating the vehicle. There are no visual
indicators when the security system is in Valet Mode. There is a parking light indication when remote starting in
Valet Mode. (3 flashes followed by 10 flashes). Also, when in Valet Mode, the keyless entry feature will still
operate.
The system can be put into valet mode one of 3 ways:
1. While holding the foot brake (12V+ brake input), cycle the key to the Ignition or 'On' position and then back
to the 'Off' position 5 times within 10 seconds. The parking lights will flash once indicating that the system
has entered Valet Mode.
2. Turn the key to the Ignition or 'On' position then using a 4-button remote press and release the lock and
trunk buttons together simultaneously for a half second. The vehicle parking lights will flash 1 time to
indicate the system has successfully entered valet mode.
**NEW**
3. The user may enter valet mode by performing the PTS vehicle remote programming procedure and make
sure there are no remotes transmitting.
Step 1: Set the vehicle to the ignition or "ON" position.
Step 2: Within 5 seconds turn ignition off
Step 3: Within 5 seconds set the vehicle to the ignition or "ON" position. (do not start)
Step 4: Press and release the foot brake 3 times within 5 seconds *parking lights will flash 1 time
to indicate programming is enabled.
Step 5: After 10 seconds, the parking light will flash 2 times, indicating the system has entered valet mode
Copyright 2016 Fi rstech ,
LLC.
Alarm and Starter System
www.firstechdata.com
Page 7
Hide quick links:
Advertisement
Table of Contents
