Figure 2-1. Lpod Connectors - Comtech EF Data LPOD Hardware Installation And Operation Manual

CONNECTIONS, INSTALLATION
2.1 Overview
This chapter summarizes the connectors provided for all necessary external connections between the
LPOD PS-1 (Figure 2-1 TOP) or PS-2 (Figure 2-1 BOTTOM) units and other equipment. Basic
installation and operational information is also provided in Sect.2.3. For a detailed overview on the
LPOD's operability (via remote M&C commands/queries), refer to Appendix B. REMOTE
CONTROL.
J10 J11
Modem Rx LNB
Power In
J3
J1
Tx In Power In
Chapter 2. SYSTEM
J1
L-Band In
COM1 J2 RF Out – C-Band shown
J6
J3 J6 J10
COM1 Modem Rx

Figure 2-1. LPOD Connectors

(TOP: PS-1 model; BOTTOM: PS-2 model)
and OPERATION
(Coax Output)
J11 J2 RF Out
LNB (Waveguide Output)
2–1
J2 RF Out – Ku-Band shown
(Waveguide Output)
J9
Output Sample