Comtech EF Data LPOD Hardware Installation And Operation Manual page 136
C-/ku-band outdoor amplifier/block up converter (buc)
Hide thumbs
Also See for LPOD:
- Installation and operation manual (224 pages) ,
- Installation and operation manual (250 pages)
Table of Contents
Advertisement
LPOD C- / Ku-Band Outdoor Amplifier/ Block Up Converter (BUC)
Appendix B
Command
(Instruction
Parameter Type
Code and
Qualifier)
IP Address
IPA=
Gateway Address
IPG=
Initialize Statistics
ISP=
Pointer
LNB Current
LCS=
Source
Arguments for
Description of Arguments
Command or
(Note that all arguments are printable ASCII
Response to
Query
18 bytes
Command or Query.
Used to set the IP address and network prefix for the
10/100 BaseT Ethernet management port, in the
format:
xxx.xxx.xxx.xxx.yy, where:
xxx.xxx.xxx.xxx is the IP address, and
yy is the network prefix (8-30)
Example: <1/IPA=192.168.001.004.24'cr'
>0001/IPA='cr''lf'
Note: Changing the IP address through the Telnet
interface requires the user to power cycle the unit, and
then restart a new Telnet session with the new IP
address. The IP address that you type into the Telnet
client software does not include the range parameter
so it would be: 192.168.1.4
Default Value: 192.168.001.004.24
15 bytes
Command or Query.
Used to set the Gateway IP address for the 10/100
Base Tx Ethernet management port, in the format:
xxx.xxx.xxx.xxx, where:
xxx.xxx.xxx.xxx is the IP address
Example: <1/IPG=192.168.001.005'cr'
>0001/IPG='cr''lf'
Default Value: 192.168.001.005
None
Command only.
Resets internal pointer to allow RNS? Queries to start
at the beginning of the stored statistics log.
Example: <1/ISP='cr'
>0001/ISP='cr''lf'
1 byte
Command or Query.
This command enables, or disables the LNB current
source.
Note: LCS must be enabled before the LNB current
can be calibrated.
0 = Disable
1 = Enable
Example: <1/LCS=1'cr'
>0001/LCS='cr''lf'
Default Value: 0
characters)
IPA=
IPA?
IPA*
IPA#
IPG=
IPG?
IPG*
ISP=
ISP?
ISP*
LCS=
LCS?
LCS*
B–18
Query
Response to
(Instruction
Command
Code and
(Target to Controller)
qualifier)
IPA?
IPG?
N/A
LCS?
Revision 3
MN-LPOD
Response to
Query
(Target to
Controller)
IPA=
xx.xxx.xxx.xxx.yy
(See Description
of Arguments for
details)
IPG =
xxx.xxx.xxx.xxx
N/A
LCS=x
(Same format as
command
arguments)
Advertisement
Table of Contents
