Comtech EF Data LPOD Hardware Installation And Operation Manual page 140

LPOD C- / Ku-Band Outdoor Amplifier/ Block Up Converter (BUC)
Appendix B
Command
(Instruction
Parameter Type
Code and
Qualifier)
Number of N/A
Unread stored
Events
Number of N/A
Unread stored
Statistics
Online Status ONL=
Part Number N/A
Arguments for
Description of Arguments
Command or
(Note that all arguments are printable ASCII
Response to
Query
3 bytes Query only.
Unit returns the Number of stored Events, which
remain Unread in the form of xxx.
Example: <1/NUE?'cr'
>0001/NUE=126'cr''lf'
3 bytes Query only.
Unit returns the Number of stored Statistics, which
remain Unread in the form of xxx.
Example: NUS=126
1 byte Command or Query.
Online status (applies only to redundancy), where:
0 = Offline (Query only) (see Note)
1 = Online
The ONL query always returns an online response if the
unit is not running in redundant mode. If redundancy is
enabled then the query will indicate the position of the
Tx waveguide switch that enables one of the units to be
connected to the antenna.
Example: <1/ONL=1'cr'
>0001/ONL='cr''lf'
Note: sending ONL=0 will not generate a syntax error;
however setting ONL to zero will not cause the unit to go
offline. The online status is determined by the TX
waveguide redundant switch position, and only the
offline unit may drive the switches. Instead of sending
ONL=0 to the online unit the ONL=1 command should
be sent to the offline unit to generate a redundant
switchover.
Various 1-96 Query only.
bytes Returns the Comtech EF Data part number of the unit.
This part number is the unit's DOTCODE at the time it
was manufactured. The DOTCODE may be up to 96
printable ASCII characters long.
Example: <1/PNM?'cr'
>0001/PNM=HPODC0.350WRSW00'cr''lf'
characters)
NUE=
NUS=
ONL=
ONL?
ONL*
PNM=
B–22
Query
Response to
(Instruction
Command
Code and
(Target to Controller)
qualifier)
NUE?
NUS?
ONL?
PNM?
Revision 3
MN-LPOD
Response to
Query
(Target to
Controller)
NUE=xxx
NUS=xxx
ONL=x
PNM=x....x
(See Description
of Arguments for
details)