Comtech EF Data LPOD Hardware Installation And Operation Manual page 147

LPOD C- / Ku-Band Outdoor Amplifier/ Block Up Converter (BUC)
Appendix B
Command
(Instruction
Parameter Type
Code and
Qualifier)
Remote Baud SBR=
Rate
Switch Bias Tee SBT=
Set FSK Address SFA=
Arguments for
Description of Arguments
Command or
(Note that all arguments are printable ASCII
Response to
Query
4 bytes Command or Query.
Set remote baud rate as follows:
2400 = 2400 baud
4800 = 4800 baud
9600 = 9600 baud
19K2 = 19200 baud
38K4 = 38400 baud
Examples: <1/SBR=9600'cr'
>0001/SBR=9600'cr''lf'
<1/SBR?'cr'
>0001/SBR=09600'cr''lf'
Note: When changing baud rates remotely the
response to the command will be returned using the
same baud rate as that used to send the command.
Default Value: 9600
1 byte Command or Query.
numeric Switches the bias tee into the through state, or into the
off state. The bias tee provides a means of muting the
LNB. The SBT state will be controlled by the amplifier
mute state while running in redundant mode, but while
the unit is not in redundant mode the bias tee may be
set independently of the amplifier mute state.
0 = Off State (mute LNB)
1 = Through State (unmute LNB)
Example: <1/SBT=1
Note: To send this command the unit must have the
bias tee option installed otherwise a mode error will
result. A mode error will also result if this command is
sent while the unit is running in redundant mode.
Default Value: 0
2 bytes, Command or Query.
nuberic Set FSK Address-between 01 to 15.
Example: <1/SFA=01'cr'
>0001/SFA='cr''lf'
Default Value: 01
characters)
SBR=
SBR?
SBR*
SBT=
SBT?
SBT*
SFA =
SFA?
SFA*
B–29
Query
Response to
(Instruction
Command
Code and
(Target to Controller)
qualifier)
SBR?
SBT?
SFA?
Revision 3
MN-LPOD
Response to
Query
(Target to
Controller)
SBR=xxxxx
(Same format as
command
arguments)
SBT=x
(See Description
of Arguments for
details)
SFA=xx
(See Description
of Arguments for
details)