Comtech EF Data LPOD Hardware Installation And Operation Manual page 142

LPOD C- / Ku-Band Outdoor Amplifier/ Block Up Converter (BUC)
Appendix B
Command
(Instruction
Parameter Type
Code and
Qualifier)
Reboot RBT=
Retrieve N/A
Configuration
Status
Online Status RED=
Arguments for
Description of Arguments
Command or
(Note that all arguments are printable ASCII
Response to
Query
1 byte Soft Reboot
1 = Reboot System
45 bytes Query only.
Used to Query the configuration status of the unit
Examples:
RCS='cr'
ATT=12.75'cr'
AMP=1'cr'
MUT=1'cr'
ONL=1'cr'
ESW=1'cr'
AOF=00.00'cr'
AFR=1'cr'
XRF=N/A'cr''lf' (see Note)
Where:
ATT= attenuation in dB
AMP= RF power amplifier state, 0=OFF, 1=ON
MUT=RF mute state, 0=un-muted, 1=muted
RED=Online status for redundancy
ESW=Redundancy state and mode,
states: 0=OFF, 1=ON Tx only, 2=ON Tx & Rx
AOF=Attenuator Offset in dB
AFR= auto fault recovery, 0=manual, 1=auto
XRF = External reference status, N/A = no external
reference, 05M for 5 MHz, and 10M for a 10 MHz
Note: XRF will always be N/A if the internal reference
oscillator option is not installed.
1 byte Command or Query.
Online status (applies only to redundancy), where:
0 = Offline
1 = Online
Note: this command is functionally identical to the ONL
command.
Example: <1/RED=1'cr'
>0001/RED='cr''lf'
characters)
RBT =
RBT?
RBT*
RCS=
RED=
RED?
RED*
B–24
Query
Response to
(Instruction
Command
Code and
(Target to Controller)
qualifier)
N/A
RCS?
RED?
Revision 3
MN-LPOD
Response to
Query
(Target to
Controller)
RBT=x
(See Description
of Arguments for
details)
RCS=x....x
(See Description
of Arguments for
details)
RED=x