Introduction; Front-Panel Features; Rear-Panel Features; Softkey Menu Trees - Fluke 5502A Operator's Manual

Introduction

Refer to this chapter for the functions and locations of the 5502A Calibrator front and
rear-panel features. Please read this information before you use the Calibrator. See the
"Front-Panel Operation" section of Chapter 4 for front-panel operation instructions. For
remote-operation instructions, see the "Remote Operation" section of Chapter 5.

Front-Panel Features

Front-panel features (including all controls, displays, indicators, and terminals) are shown
in Figure 3-1. Each front-panel feature is given in Table 3-1.

Rear-Panel Features

Rear-panel features (including all terminals, sockets, and connectors) are shown in
Figure 3-2. Each rear-panel feature is given in Table 3-2.

Softkey Menu Trees

The Setup softkeys are identified in Figures 3-3 and 3-4. The Setup softkeys go with the
Calibrator front-panel  key. The functions of the five softkeys are identified by name
information shown directly above each key. The softkey names change during operation
so you can quickly access many different functions.
A group of softkey names is a menu. A group of connected menus is a menu tree.
Figure 3-3 shows the SETUP menu tree structure. Figure 3-4 tells you about each SETUP
menu tree display. Table 3-3 shows the factory-default parameters for the SETUP menu
tree. To change the SETUP menus to their default values, use the softkey SETUP in the
Format NV Memory menu (see Figure 3-4, menu F).
3
Features
Introduction
3-3