Introduction; Unpack And Inspection - Fluke 5502A Operator's Manual

Introduction

This chapter has instructions to unpack and install the Calibrator, select the line voltage,
replace the fuse, and connect to line power. Instructions for cable connections other than
line power are in these chapters:
•
UUT (Unit Under Test) connections: Chapter 4, "Front Panel Operation"
•
IEEE-488 parallel interface connection: Chapter 5, "Remote Operation"
•
RS-232 serial interface connection: Chapter 5, "Remote Operation"
To prevent possible electrical shock, fire, or personal injury:
•
Properly terminate the sense leads to prevent exposure to
hazardous voltages on the sense terminals. The voltage
sense terminals are at output voltage when the two-wire
function is set.
•
Do not touch exposed metal on banana plugs, they can have
voltages that could cause death.
•
Do not use a two-conductor mains power cord unless you
install a protective ground wire to the Product ground
terminal before you operate the Product.
•
Make sure that the Product is grounded before use.

Unpack and Inspection

The calibrator is shipped in a container to prevent damage. Examine the calibrator
carefully for damage and immediately report damage to the shipper. Instructions for
inspection and claims are included in the shipping container.
When you unpack the calibrator, make sure that you have all the standard equipment in
Table 2-1. Examine the shipping list to make sure other items that you purchased are
included. Refer to the "Accessories" section in Chapter 8 for more information. Report
missing items to the point of purchase or to the nearest Fluke Calibration Service Center
(see "Contact Fluke Calibration" in Chapter 1). A performance test is in the
"Maintenance" section of Chapter 7.
If you ship the calibrator to Fluke Calibration, use the initial container. If it is not
available, you can get a new container from Fluke Calibration with the Calibrator model
and serial number.
Calibrator
Mains Power Cord
5502A Getting Started Manual
5502A Operators Manual on CD-ROM
Warning
Table 2-1. Standard Equipment
Item Model or Part Number
5502A
See Table 2-2 and Figure 2-2
4155209
4155227
2-3