Multi-Channel View Aux And Direct Path Channels - Roland VS-2400CD Owner's Manual

14. LINK Switch
LINK combines the CH EDIT ChLink and F.LINK parameters. Click
to the right of "LINK" and select the desired type of linking from the
pop-up menu, or turn off linking. The LINK switch occupies the
combined lower edge of both of the channels it controls.

Multi-Channel View Aux and Direct Path Channels

Direct Path Parameters
1. Source
Click Source and choose the signal to be assigned to the Direct path.
2. Pre/Post Switch
This sets the Direct path to receive a channel's signal before or after the channel fader.
3. AUTOMIX STATUS (A) Button
When Automix is on, repeatedly click this button to set the Direct path' Automix status.
4. Final Level Knob
Drag this knob to set the final level of the Direct path.
Aux Bus Parameters
1. PRE/POST Switch
Click the PRE/PST switch to configure the Aux bus to accept channel
signals from before or after the channel faders.
2. AUTOMIX STATUS (A) Button
When Automix is on, repeatedly click the AUTOMIX STATUS button
to set the Aux bus's Automix status.
3. Linked Aux Bus Balance
When an odd/even pair of aux busses is linked, this knob becomes active (see below)
and allows you to set the left/right balance of the pair of busses.
4. Aux Bus Master Level
Drag this knob to set the master level of the Aux bus.
5. LINK
To link or un-link odd/even Aux bus pairs, click the LINK button so it
lights. When two Aux busses are linked, their appearance changes
onscreen to reflect their combined operation.
In the VGA, linked Aux busses change the way in which their Aux send
sliders are shown in the various channel views and the track controls, as
explained on Page 425.
Roland VS-2400CD Owner's Manual
33—VGA Main Display Mixer Views
www.RolandUS.com
147, 151
1.
2.
3.
4.
1.
2.
3.
4.
5.
431