Drive Check - Roland VS-2400CD Owner's Manual

4. Press F3 (ClrPrt)—the appears.
5. Set Surface Scan to:
6. Press F5 (OK). The VS-2400CD asks if you're sure you want to clear selected drive:
7. Press ENTER/YES to clear the drive, or EXIT/NO to cancel.
8. If you want to proceed, press ENTER/YES. To cancel the operation, press EXIT/NO.
9. If you pressed ENTER/YES, the VS-2400CD asks if you want to save any recent
10. Press ENTER/YES to save the project before clearing the drive, or EXIT/NO to

Drive Check

If you're experiencing problems loading a project, copying it or backing it up, you can
run a Drive Check operation to determine if the problem is with your data—if not, you
may have a connection problem or a hardware malfunction. Drive Check examines the
directory that keeps track of where your files are, and seeks out potential problems
with your data. When it's done, it displays a report of its findings.
Roland VS-2400CD Owner's Manual
• Off—to skip a check of the platter surface in the partition's area of the hard
drive during initialization.
• On—so that it checks the platter surface by performing an automatic read/write
test after initialization. This can take a while, but it's a good thing to do
periodically.
If you pressed ENTER/YES, the VS-2400CD double-checks to make sure you want
to proceed, since you're about to wipe everything on the selected drive/partition.
changes to the currently loaded project.
proceed without doing so.
7—Project and Drive Operations
Information
about the
selected drive/
partition
Selected drive
Drive Check found no
problems with this drive.
www.RolandUS.com 111