Turning Off The Vs-2400Cd - Roland VS-2400CD Owner's Manual

4—Setting Up and Basic Operations

Turning Off the VS-2400CD

It's important the you don't simply flip the VS-2400CD's POWER switch to turn it off—
always use the procedure below to prevent damage to your data.
If you'd like to restart the VS-2400CD—perhaps while troubleshooting a problem—use
the procedure below as well.
Turning Off the VS-2400CD
1. Hold down SHIFT, and press STOP•SHUTDOWN. The following dialog appears:
2. If you wish to turn off or restart the VS-2400CD, press ENTER/YES. If not, press
3. If you've made changes to the currently loaded project you'd like to preserve, press
If you're shutting down the VS-2400CD when a factory demo song—or any other
protected project—is loaded, you won't be prompted to store the current song.
4. If you'd like to restart the VS-2400CD, hold down SHIFT and press
If you need to move the VS-2400CD after shutting it down, wait 30 seconds or so to give
its hard drive a chance to stop spinning in order to avoid damaging it.
78
EXIT/NO to cancel the operation. If you press ENTER/YES, a dialog like this one
appears:
ENTER/YES. If you haven't, press EXIT/NO.
In either case, the VS-2400CD takes a few moments to prepare to shut down—and
to save your project if you pressed ENTER/YES in Step 3. When the VS-2400CD is
ready to be powered off, the following message appears:
PLAY•RESTART—the VS-2400CD begins its power-up sequence. If you'd like to
shut down the VS-2400CD, flip its rear-panel POWER switch to its Off position.
www.RolandUS.com
The name of the
currently loaded project.
The project's sample rate and
recording mode (Page 93).
Roland VS-2400CD Owner's Manual