R-Bus; Rss Pan Setup - Roland VS-2400CD Owner's Manual

R-BUS

On this screen, you can activate remote control of an R-BUS device connected to
the R-BUS jack (Page 50). You can also set the device's configuration parameters. To turn
on remote control of an R-BUS device, turn on the remote control parameter for the
R-BUS jack to which it's connected.
If a Roland RPC-1 (R-BUS PCI card) is connected to an R-BUS connector, turn its
remote control parameter off if it isn't turned off already.
Once you've activated the device's remote control, display its setup parameters by
pressing F1 (R-BUS)—to display the configuration screen for the device connected to
the VS-2400CD's R-BUS jack.
F1 (R-BUS) appears only when a remote-controllable R-BUS device is connected to the
R-BUS jack and remote control is turned on.
In the "Supplemental Information" chapter, you'll learn how to set each R-BUS device's
configuration parameters. See:
•
•
If you're using a DIF-AT, see "Using a Roland DIF-AT" on Page 444.

RSS PAN SETUP

The VS-2400CD's RSS Pan effect algorithm allows you to add depth to
your recordings. See "RSS PAN" on Page 220 to learn more about using
the RSS Pan feature.
Roland VS-2400CD Owner's Manual
"DIF-AT Settings" on Page 443.
"AE-7000 Settings" on Page 446.
27—UTILITY Menu Parameters
• "ADA-7000 Settings" on Page 445.
• "VSR-880 Settings" on Page 448.
www.RolandUS.com
UTILITY menu
F1 (R-BUS)
UTILITY menu
F2 (RSSPan)
371