Vga - Roland VS-2400CD Owner's Manual
24tr/96khz/24-bit digital studio workstation
Hide thumbs
Also See for VS-2400CD:
- Appendices (156 pages) ,
- Service notes (49 pages) ,
- Mixer block diagram (1 page)
Table of Contents
Advertisement
METER POSITION
This parameter sets whether metered input, track, Aux master and FX return channel
signals are shown before or after their faders on the MB-24.
TIME DISPLAY
TIME DISPLAY determines the time shown by the MB-24's time counter. It can show:
•
•
•
METER SCALE
When the METER SCALE parameter is set to x1 ("times 1"), displayed levels are shown
in their actual scale. Set METER scale to x2 to zoom in for more precise metering.
VGA
The following parameters let you set up the VS-2400CD's output to a connected VGA
monitor—we've already described them briefly on Page 64, but here's some additional
detail. If you're not using an external monitor, these settings have no effect.
VGA OUT
The VGA OUT switch turns the VS-2400CD's feed to a connected monitor on or off.
REFRESH RATE
Every monitor constantly re-draws, or "refreshes," the image it displays. The faster the
monitor can do this, the less likely you are to notice it doing so. When a monitor
refreshes too slowly, you can see it flicker, which can wear on your eyes. You can set the
parameter to 60Hz, 66Hz, 70Hz or 75Hz.
Consult your VGA monitor's documentation to learn its recommended refresh rate. If
you select a value the monitor doesn't support, image quality may be poor, and damage
to the monitor may result.
H.POSITION
Adjust the H.POSITION ("Horizontal Position") parameter if you'd like to shift the
image on your VGA monitor to the left (negative values) or to the right (positive values).
You can move as far as -5 to the left or +5 to the right.
V.POSITION
Adjust the V.POSITION parameter if you'd like to shift the image on your VGA monitor
downward (negative values) or upward (positive values) by as much as -11 down or +11
up.
Roland VS-2400CD Owner's Manual
MEASURE/BEAT—using the current time location display's (Page 122) measure and
beats counter.
TIME CODE—using the current time location display's time code counter.
CLOCK/SCENE—so that the current clock time appears at the left of the counter,
and the number of the currently selected scene appears at its right.
27—UTILITY Menu Parameters
www.RolandUS.com
355
Advertisement
Table of Contents
