Supplemental Information; R-Bus Remote Control; Dif-At Settings - Roland VS-2400CD Owner's Manual

Supplemental Information

R-BUS Remote Control

You can remotely control a variety of connected R-BUS devices right from the
VS-2400CD. To learn how to activate remote control of an R-BUS device, see Page 371.
The following sections describe the parameters in each device that you can set from the
VS-2400CD.
To leave any of the remote control screens described in these sections—and return to
the VS-2400CD's R-BUS CONFIG screen—press F6 (EXIT).
The parameters discussed in the following sections appear on the VS-2400CD's R-BUS
screen only when remote control of the respective device has been activated, as
described on Page 371.
When you've connected an RPC-1 card to the VS-2400CD's R-BUS jack, disable remote
control of that R-BUS jack.

DIF-AT Settings

INPUT CH STATUS 1-8
You can set the status of each track on the connected recorder connected to the DIF-AT.
You can choose:
•
•
INPUT SELECT
INPUT SELECT chooses the desired type of digital recorder. You can select:
•
•
Roland VS-2400CD Owner's Manual
PLY—to set the track so that it plays back any audio recorded on the track.
REC—to arm the track for recording.
ADAT—to use the DIF-AT with an ADAT-format recorder.
TDIF—to use the DIF-AT with a T-DIF-format recorder.
www.RolandUS.com 443