Table of Contents
Advertisement
Indication
Value
You can assign a pedal to successively switch registrations (p. 11). Each time you press the pedal, you will switch to the next
registration.
* Pedal function settings take priority in the following order: "Reg. Pedal Shift" 0 "Center/Left Pedal. "
Reg. Pedal
Off
Shift
Left Pedal
Center Pedal
MIDI-related settings
Preventing Doubled Notes When Connected to a Sequencer (Local Control)
When you have a MIDI sequencer connected via USB, set this parameter to Local Off.
Since most sequencers have their Thru function turned on, notes you play on the keyboard may be sounded in duplicate, or
get dropped. To prevent this, you can enable the "Local Off" setting so that the keyboard and internal sound generator will be
Local Control
disconnected.
Off
On
MIDI Transmit Channel Settings (MIDI Transmit Ch.)
MIDI
This setting specifies the MIDI channel on which the unit will transmit.
Transmit Ch.
This unit will receive all sixteen channels (1–16).
Off, 1–16
Overall operation settings
Changing the Language Displayed in the Screen (Language)
Language
You can change the language that is displayed in the screen.
English, Japanese, Chinese
Adjusting the Brightness of the Display (Display Contrast)
Display
Contrast
You can adjust the brightness of the piano's display.
1–10
Specifying the Time Until the Operating Panel Is Dimmed (Screen Saver)
When no operation has been performed for a specified length of time, the display will go blank and the operating panel button
Screen Saver
LEDs will go dark. The display reappears when you perform an operation.
You can specify the time until the panel goes dark.
Off, 30 sec., 1 min., 5 min., 10 min.
Specifying a Maximum Volume (Volume Limit)
You can specify a maximum volume value. This lets you prevent loud sound from being produced unintentionally.
Volume Limit
MEMO
You can also set the volume limit by holding down the [ ] knob and turning the [ ] knob.
20, 40, 60, 80,100
Making the Power Automatically Turn off After a Time (Auto Off)
Auto Off
With the factory settings, the unit's power will automatically be switched off 30 minutes after you stop playing or operating the
unit. If you don't want the power to turn off automatically, change the "Auto Off" setting to "Off" as follows.
Off, 10, 30, 240 (min)
Explanation
Pressing the pedal does not change the registration.
The soft pedal can be used only for switching registrations. In this case, the function assigned to the soft pedal
cannot be used.
The sostenuto pedal can be used only for switching registrations. In this case, the function assigned to the
sostenuto pedal cannot be used.
Local Control is off.
The keyboard is disconnected from the internal sound generator. Playing the keyboard will not produce sound.
Local Control is on.
The keyboard is connected to the internal sound generator.
Making Various Settings (Function Mode)
27
Advertisement
Table of Contents
