Roland VS-2400CD Owner's Manual page 399
24tr/96khz/24-bit digital studio workstation
Hide thumbs
Also See for VS-2400CD:
- Appendices (156 pages) ,
- Service notes (49 pages) ,
- Mixer block diagram (1 page)
Table of Contents
Advertisement
Selecting the Desired Meters
The strip provides a set of meters for each of the signal types listed above. You can
select the meters you want to display in either of two ways. You can use the:
•
•
To display FX return levels using the F buttons, press PAGE until "FX RTN" appears
above F5 and then press F5 (FX RTN).
The meters strip on the VGA operates in much the same way as the LCD meters strip.
See Page 120 for additional info.
Pre and Post
You can select pre or post metering when you're viewing anything other than input and
output signals. (To learn about pre and post metering, see the note on Page 117.)
Select the desired type of metering by:
•
•
The PEAK HOLD Button
Click the PEAK HOLD button so that it lights yellow to make your signals' loudest
levels "stick" in their meters until you release them. The Peak Hold feature helps ensure
that you don't miss any unexpected level peaks should you look away from the meters.
To "un-stick" the meters, click the PEAK HOLD button again to unlight it.
Roland VS-2400CD Owner's Manual
meters strip control buttons—Click:
•
INPUT—to display input signal levels.
•
IN 1-16—to display input channel levels.
•
TR 1-24—to display track channel levels.
•
FX1-4 RTN—to display internal effect return levels.
•
AUX/DIR—to display Aux bus and Direct path
levels.
•
OUTPUT—to display output levels.
PAGE and F buttons on the VGA or on the VS-2400CD—Press PAGE until "INPUT"
appears above F1 and press:
•
INPUT—to display input signal levels.
•
IN MIX—to display input channel levels
•
TR MIX—to display track channel levels
•
AUXDIR—to display Aux bus and Direct path levels.
•
OUTPUT—to display output levels.
clicking the meters strip's PRE or POST button.
use the PAGE and F buttons on the VGA or VS-2400CD:
1. Press PAGE until "INPUT" appears above F1.
2. Click or press:
•
F6 (To Pre)—to select pre metering.
•
F6 (To Pst)—to select post metering.
31—VGA Main Display Home Screen
PEAK HOLD button
www.RolandUS.com
The TR 1-24
button is red to
indicate that the
track channel
meters are
being displayed.
399
Advertisement
Table of Contents
