Snapshot Recording Of Parameter Values; Playing Back Automix Data; Editing Automix Data; Automix Editing Concepts - Roland VS-2400CD Owner's Manual
24tr/96khz/24-bit digital studio workstation
Hide thumbs
Also See for VS-2400CD:
- Appendices (156 pages) ,
- Service notes (49 pages) ,
- Mixer block diagram (1 page)
Table of Contents
Advertisement
25—Automix
Snapshot Recording of Parameter Values
A snapshot registers the position of the now line and captures the
current parameter values on all Automix tracks that are Write-
enabled. When you play back the project with Automix turned on—
and the Automix tracks set to play back—the parameter values
stored in the snapshot are recalled when the now line reaches the
location at which the snapshot was taken.
Taking a Snapshot
1. Move the now line to the location at which you want to take a snapshot.
2. If Automix isn't already turned on, press AUTOMIX so that it lights solidly.
3. Hold down AUTOMIX and press the AUTOMIX STATUS button for any Automix
4. While holding down AUTOMIX, press AUTOMIX REC—AUTOMIX starts flashing
5. While holding down AUTOMIX, press TAP—the current parameter values for the
6. Hold down AUTOMIX and press REC so that AUTOMIX lights solidly to show it's
7. Hold down AUTOMIX and press the AUTOMIX STATUS button for each Write-
Playing Back Automix Data
To play back Automix data:
1. If AUTOMIX isn't lit solidly, press it so that it is to show that Automix mode is on. If
2. Hold down AUTOMIX and set the AUTOMIX STATUS button for each of your
3. Play the project.
Editing Automix Data
Automix Editing Concepts
The AUTOMIX EDIT Screen
Automix editing takes place on the AUTOMIX EDIT screen. To get there:
1. While holding down SHIFT, press AUTOMIX.
2. Press F1 (EDIT)—the AUTOMIX EDIT screen appears.
322
track whose settings you want to capture so that the button flashes to signify that
the Automix track is in Write mode.
to signify that it's ready to take the snapshot.
Write-enabled tracks are captured in the snapshot.
no longer ready to record.
enabled Automix track to make it solidly lit for playback.
it's flashing, hold down AUTOMIX and press REC so that AUTOMIX lights solidly.
Automix tracks to light it solidly so it plays back.
www.RolandUS.com
Roland VS-2400CD Owner's Manual
Advertisement
Table of Contents
