Using Midi Messages To Select Patches; Level Pan; Mute - Roland SoundCanvas SC-88 Pro Owner's Manual

Using MIDI messages to select Patches

1.
2.
S
Normally when a MIDI program change message is received, the Instrument of a Part
will change. However if you set the MIDI channel for the Patch, the Patch will change
when a program change message is received (p.131).
With the Patch MIDI CH settings of "
select the Instrument of the corresponding Part.
* With the factory settings, the Patch MIDI CH is set to
Press the [ALL] button to make the button indicator light.
Use MIDI CH [l l l l ] [r r r r ] to set the MIDI channel.
LEVEL PAN
REVERB CHORUS
K SHIFT MIDI CH
Patch Channels
1
PART
ALL
LEVEL

MUTE

REVERB
SC - 55
MAP
KEY SHIFT
SC - 88
MAP
DELAY
For example, suppose that the MIDI channels of the Patch and Part were set to the
same value. In this case, an incoming program change on channel 1 [C0H 01H] will
select Patch
Pick) specified for the Patch will be used.
Patch MIDI CH:
Part A01 MIDI CH: "A01"
If you want program changes to once again select the Instrument of Part A01, set the
Patch MIDI CH to " ".
* It takes awhile until the sound can be heard after you change the Patch.
Chapter 2. Parts and paramters
" or "
1 2 3 4
INSTRUMENT
PAN
CHORUS
MIDI CH
2
, but the Instrument of Part A01 the instrument (TC Front
"A01"
", incoming program changes will
.
41