Initialize; Initialize All Parts To The Factory Settings; Initialize For Gm/Gs - Roland SoundCanvas SC-88 Pro Owner's Manual

Initialize

Initialize all Parts to the factory settings

1.
2.

Initialize for GM/GS

1.
2.
118
This procedure will initialize all the settings of this unit to the factory settings. This will
also initialize System parameters (p.36) and User parameters (p.96).
While holding down [SELECT], simultaneously press both the INSTRU-
MENT [l l l l ] [r r r r ] buttons.
The display will ask "
To initialize, press [ALL].
To quit without initializing, press [MUTE].
* After the initialization has been performed, the indications in the display for the parameters listed
below will show the factory default settings. In fact, however, the settings will not yet at that point
be at the defaults. They will be placed at the defaults after you turn power on, then off again.
In Mode, OUT/THRU, IN B Sel. ( p.135)
When you wish to playback song data carrying the GM/GS logo, you need to initialize
this unit for GM/GS settings. When this is done, this unit will be set to the basic GM/GS
settings appropriate for playing back song data carrying the GM/GS logo.
The beginning of song data carrying the GM/GS logo contains data which requests
the sound source to initialize itself (General MIDI System On, GS Reset p.133). This
means that if you are playing back the song data from the beginning, initialization will be
done automatically, and there is no need for you to do it using the front panel buttons.
* Even if this unit is initialized for GS/GM, the System parameter settings (p.36) will not be affected.
* Even if the Backup Switch ( p.37) is on, the following procedure will rewrite it to the factory setting.
(For GM) While holding down [SELECT], press PART [r r r r ].
(For GS) While holding down [SELECT], press INSTRUMENT [r r r r ].
The display will ask "
If you perform this operation in Double Module mode (p.116), the display will ask "
". Use INSTRUMENT [l] [r] to specify which module A or B will be ini-
tialized.
To initialize, press [ALL].
To quit without initializing, press [MUTE].
1
USER
INST SELECT
EFX ON/OFF
Chapter 5. Convenient functions
".
" or "
2 1
GM
PART
ALL
LEVEL
MUTE
REVERB
SC - 55
MAP
KEY SHIFT
SC - 88
MAP
DELAY
VIB RATE VIB DEPTH
CUTOFF
ATTACK DECAY
EFX TYPE EFX PARAM
"
1
ALL
INSTRUMENT
1
GS
PAN
CHORUS
MIDI CH
VIB DELAY
RESONANCE
RELEASE
EFX VALUE