Changing The Batch Transmission On/Off Home Position Setting; Well Log Transmission - Ricoh FAX5600L Operator's Manual

ADVANCED FEATURES
Note: You can have up to 50 fax messages in the same batch.
Messages using Confidential Transmission cannot be put into a batch.
Cross-reference
Send Later: see page 60.
Changing the Batch Transmission Home Position Setting On/Off
In a new machine, this setting is "On". If you wish to change this setting, use the
following procedure. (See page 10 if you need more information about the User
Parameter settings adjustment procedure).
1.
Function 6 0 2
2. The settings for switch 00 are now
shown on the bottom line of the display.
↓
3. Press until the settings for switch 03
are shown.
The setting that you need to change is
digit 4.
4. If you wish to change the setting, press
5. Finish:
Yes Function

Well Log Transmission

Using this feature, you can transmit a document that is longer than the maximum
limit, without having to cut it up into separate sheets. However, you must contact a
service technician to have this feature switched on. The name of this feature is
taken from oil well borehole surveying. A well log is a vertical profile of a borehole,
drawn to scale, showing important data. A well log can be several yards long.
Caution
If this feature is switched on permanently, users must stay by the machine while their
documents are being scanned. This is because, if the document jams, the machine may take
much longer than usual to recognize the jam; this could result in excessive wear and tear of
the mechanical components of the scanner.
If a jam does occur, press the Stop key immediately.
Economy Transmission: see page 66.
2 2 2 9 1
USER PARAMETER
DEFAULT:
SWITCH00:
.
4
TRANSMISSION
PRINT LIST
01000000
TO END
YES
01000000
Digit 4
0: The home position setting is "Off".
Batch Transmission will be disabled
after transmission. Use this if you only
wish certain transmissions to be
batched. However, you will have to
press the Batch Transmission User
Function Key for every transmission
you wish to be batched.
1: The home position is "On". If you
use Batch Transmission, it will stay on
for all transmissions, until you turn off
the lamp under the User Function Key.
125