ADVANCED FEATURES
Changing the Specified Image Area On/Off Home Position Setting
In a new machine, this setting is off. If you change this setting to "On", the image
area that you input (using Function 96; see below) will be used for all of your
transmitted pages, unless you switch off the light under the User Function Key
that you programmed for this feature.
1.
Function
6
0
2
2. The settings for switch 00 are now
shown on the bottom line of the display.
↓
3. Press
until the settings for switch 03
are shown.
The setting that you need to change is
digit 5.
4. If you wish to change the setting, press
5. Finish:
Yes
Function
Specifying an Image Area
1.
Function
6
0
2
2. Input the skip length then press
You must enter a three digit value.
For example, for 75 mm, input 075.
3. Input the scan length then press
You must enter a three digit value.
For example, for 95 mm, input 095.
4. Finish:
Yes
The machine returns to the transmission procedure.
Specified Image Area is available only when you are doing one of the following:
Memory Transmission (including Confidential Transmission and Transfer
Request)
Storing a document for Polling Transmission
Storing an Auto Document
2
2
2
9
1
USER PARAMETER
DEFAULT:
SWITCH00:
.
4
2
2
2
9
6
IMAGE AREA
SKIP LENGTH:
SCAN LENGTH:
↓
.
IMAGE AREA
SKIP LENGTH:
SCAN LENGTH:
↓
.
TRANSMISSION
PRINT LIST
01000000
TO END
YES
01000000
Digit 5
0: The home position is "Off". After
transmission, Specified Image Area will
switch itself off.
1: The home position is "On". After
transmission, Specified Image Area will
stay active and the lamp under the
User Function Key will stay lit.
YES
000
000
YES
075
000
1 inch is 25.4 mm. You must input
the dimensions in mm.
TO END
MM
MM
TO END
MM
MM
119