Multi-Step Transfer - Ricoh FAX5600L Operator's Manual

ADVANCED FEATURES

Multi-step Transfer

The principles of the Two-step Transfer feature can be used to build up a
multi-step facsimile network. This will work using either analog (Group 3) or digital
(Group 4) lines. An example follows.
Terminal C: Group 1
Terminals I and J
Group Transfer Stn. = D
Terminal C: Group 2
Terminals E, F, G, and H
A
Dials
#**01
(Transfer
Request)
To set up this network, the following programming must be done:
Terminal C must contain two preprogrammed groups. Group 1 must contain
terminals I and J. Group 2 must contain terminals E, F, G, and H. In Group 1,
terminal D must be specified as the Group Transfer Station.
Terminal B must contain a preprogrammed group (Group 1). This group must
contain two numbers, # ∗∗ 01, and # ∗∗ 02. These specify transfer using groups 1
and 2 that are stored in the Group Transfer Station. In Group 1, C must be
specified as the Group Transfer Station.
The ID codes of terminals A, B, C, and D must be the same.
To start the operation, terminal A does a transfer request using terminal B as the
broadcaster and # ∗∗ 01 as the end receiver; this specifies transmission to the
numbers stored in Group 1 at terminal B.
Cross-reference
Group Transfer Station: see page 41.
B
Terminal B: Group 01
#**01
#**02
Group Transfer Stn. = C
NETWORKING
I
J
D
C
E
F
G
H
93