HP E1563A User Manual page 69

:TTLT<n>[:STATe]
Comments
:TTLT<n>[:STATe]?
OUTPut:TTLT<n>[:STATe] ON | 1 | OFF | 0 enables or disables the specified
TTL Trigger line for outputting the source set by the OUTPut:TTLT<n>:SOURce
command.
•
<n> can have the value 0 through 7 (TTLT0 - TTLT7).
•
Resource conflicts will occur if either the trigger or sample source is already
using a TTL line you attempt to enable as an OUTPut line. The OUTPut
TTLT line will not be enabled and a "Settings Conflict" error will occur.
•
Setting the trigger or sample source to a TTL trigger line that has its output
state ON will result in a settings conflict error and the output state will be
changed to OFF. The specified trigger line will be assigned to the sample or
trigger source.
•
TRIG:MODE MASTer<n> | SLAVe<n> will disable all other
OUTPut:TTLT<n>:STATe settings. The only outputs that will occur are those
defined in the MASTer-SLAVe relationship.
•
Executable when initiated: No
•
Coupled Command: Yes
•
Reset (*RST) Condition: All lines set to OFF.
OUTPut:TTLT<n>[:STATe]? queries the specified TTL Trigger line (TTLT0-
TTLT7) to determine if it is enabled (1) or disabled (0).
Digitizer Command Reference 69