HP E1563A User Manual page 136

TRIG:MODE MASTer0 pairs TTLT0 (sample) with TTLT1 (trigger)
The MASTer0 module will function with all SLAVe0 modules.
1) The trigger source from the slave can be set
with the Trigger Source/Control Register bits
0,1,2,3,4,7,8,9,12,13,14, and 15. .
MODE
SLAVe0
SLAVe2
SLAVe4
SLAVe6
136 HP E1563A and E1564A Register-Based Programming
Figure B-1. Master Module Configuration.
Sample Trigger
signal signal
TTLT0 TTLT1
TTLT2 TTLT3
TTLT4 TTLT5
TTLT6 TTLT7
2) SLAVe0 sets the TTLT0 line as if
source is TTLT0 and sets the TTLT1 line as if the
trigger source is
TTLT1
dedicated for synchronization between the
modules in the master-slave mode. You should
not use these lines for any other purpose.
the sample
. These lines are simply
Appendix B