HP E1563A User Manual page 33

TRIG:MODE SLAVe0 pairs TTLT0 (sample) with TTLT1 (trigger)
A SLAVe0 module will function with other SLAVe0 modules and
the MASTer0 module.
1) The trigger source from the slave can be set
with TRIG:SOURce2 IMM | INT1-4 | EXT |
.
TTLT<n>
MODE
SLAVe0
SLAVe2
SLAVe4
SLAVe6
Figure 2-5. Slave Module Configuration Block Diagram.
SLAVe
Sample signal
TTLT0
TTLT2
TTLT4
TTLT6
2) SLAVe0 sets the TTLT0 line as if it were
SAMP:SOUR TTLT0 and sets the TTLT1 line as
if it were
TRIG:SOUR1 TTLT1
queries or TRIG:SOUR? will not
SAMP:SOUR?
return these settings. These lines are simply
dedicated for synchronization between the
modules in the master- slave mode. You should
not use these lines for any other purpose with the
OUTPut, SAMPle or TRIGger commands.
Digitizer Application Information
. However, the
33