HP E1563A User Manual page 41

Parameters
Parameter Types. The following table contains explanations and examples of
parameter types you might see later in this chapter.
Optional Parameters. Parameters shown within square brackets ([ ]) are optional
parameters. (Note that the brackets are not part of the command; do not send them
to the instrument.) If you do not specify a value for an optional parameter, the
instrument chooses a default value. For example, consider the
TRIGger:LEVel<chan>? [MIN | MAX] command. If you send the command
without specifying a MINimum or MAXimum parameter, the present
TRIGger:LEVel value is returned for the specified channel. If you send the MIN
parameter, the command returns the minimum trigger level allowable. If you send
the MAX parameter, the command returns the maximum trigger level allowable. Be
sure to place a space between the command and the parameter.
Linking
Linking IEEE 488.2 Common Commands with SCPI Commands. Use only a
semicolon between the commands. For example:
Commands
*RST;OUTP:TTLT4 ON
Linking Multiple SCPI Commands From the Same Subsystem. Use only a
semicolon between commands within the same subsystem. For example, to set
trigger level, trigger slope and the trigger source which are all set using the TRIGger
subsystem, send the following SCPI string:
TRIG:LEVel 1.5;SLOPe NEG;SOURce EXT
Linking Multiple SCPI Commands of Different Subsystems. Use both a
semicolon and a colon between commands of different subsystems. For example, a
SAMPle and OUTPut command can be sent in the same SCPI string linked with a
semicolon and colon (;:) as follows:
SAMP:COUNt 10;:OUTP:TTLT4 ON
Parameter
Type
Numeric Accepts all commonly used decimal representations of number
including optional signs, decimal points, and scientific notation.
123, 123E2, -123, -1.23E2, .123, 1.23E-2, 1.23000E-01.
Special cases include MINimum, MAXimum, and DEFault.
Boolean Represents a single binary condition that is either true or false.
ON, OFF, 1, 0
Discrete Selects from a finite number of values. These parameters
use mnemonics to represent each valid setting.
An example is the TRIGger:SOURce <source> command where
source can be OFF, BUS, EXT1-2, HOLD, IMM, INT1-4 or
TTLT0-7.
Table 3-1.
Explanations and Examples
SAMP:COUNt 25;*WAI
or
Digitizer Command Reference 41