HP E1563A User Manual page 106

SCPI Command Quick Reference
The following tables summarize SCPI commands for the HP E1563A and HP E1564A C-size Digitizers.
ABORt
CALCulate[<channel>]
:LIMit:FAIL?
:LIMit:LOWer[:STATe] ON | 1 | OFF | 0
:LIMit:LOWer[:STATe]?
:LIMit:LOWer:DATA < value > | MIN | MAX
:LIMit:LOWer:DATA? [MIN | MAX]
:LIMit:UPPer[:STATe] ON | 1 | OFF | 0
:LIMit:UPPer[:STATe]?
:LIMit:UPPer:DATA < value > | MIN | MAX
:LIMit:UPPer:DATA? [MIN | MAX]
CALibrate
:DAC:VOLTage <voltage> | MIN | MAX
:DAC:VOLTage? MIN | MAX
:DATA?
:GAIN[<channel>] [<readings>][,<rate>][,ON | 1 | OFF | 0]
:SOURce INTernal | EXTernal
:SOURce?
:STATe ON | 1 | OFF | 0
:STATe?
:STORe
:VALue <voltage>
:VALue?
:ZERO[<channel>] [<readings>][,<rate>]
:ZERO[<channel>]:ALL? [<readings>][,<rate>]
106
Command Description
Stops any measurement in progress
and puts instrument in the idle state.
Defaults to channel 1 if none specified.
Checks for a limit failure.
Enable lower limit checking.
Set lower limit value.
Enable upper limit checking.
Set upper limit value.
Calibration commands.
E1564A: sets internal cal source
Returns calibration constants.
Perform gain cal using :VAL <voltage>.
Set calibration source (INTernal is
available only on E1564A).
Enable/disable ability to calibrate.
Store cal constants in NV memory.
Tell digitizer what cal value is input.
Perform zero cal on current range.
Perform zero cal on all ranges and
return zero cal status response.